ASME A112.6.7 pdf free download

ASME A112.6.7-2001 pdf free download.ENAMELED AND EPOXY COATED CAST IRON AND PVC PL ASTIC SANITARY FLOOR SINKS.
This Standard applies to enameled and epoxy coated cast iron and PVC plastic sanitary floor sinks and includes requirements for material, construction, inspec- tion, testing, and marking. The provisions of this Standard are not intended to prevent the use of any alternate materials or methods of construction, provided any such alternate meets the intent of this Standard. 1.2 Units of Measurement Values are stated in U.S. Customary units and the International System of Units (SD). The U.S. Customary units shall be considered as the standard. 1.3 Reference Standards The following standards are referenced in this docu- ment. Unless otherwise specified, the latest edition shall apply. ASME A112. 19.1, Enameled Cast Iron Plumbing Fix- tures ASME A112.21.1′, Floor Drains Publisher: American Society of Mechanical Engineers (ASME), Three Park Avenue, New York, NY 10016; Order Department: 22 Law Drive, Box 2300, Fairfield, NJ 07007-2300. ASTM A 888, Hubless Cast Iron Soil Pipe and Fittings for Sanitary and Storm Drain, Waste and Vent Piping Applications ASTM D 522, Mandrel Bend Test of Attached Organic Coatings ASTM D 523, Test Method for Specular Gloss ASTM D 1784, Rigid Poly (Vinyl Chloride) (PVC) Compounds and Chlorinated Poly (Vinyl Chloride) (CPVC) Compounds ASTM D 2665, Poly (Vinyl Chloride) (PVC) Plastic Drain, Waste and Vent Pipe and Fitings Publisher: American Society for Testing and Materials (ASTM)，100 Barr Harbor Drive， West Consho- hocken, PA 19428 ANSI Z124.6, Plastic Sinks Publisher: International Association of Plumbing and Mechanical Officials (IAMPO)， 20001 E. Walnut Drive, Walnut, CA 91789-2825 1.4 Floor Sink As covered in this Standard, a floor sink is a receptor drain that is designed and installed for the purpose of draining indirect waste to the sanitary drainage system. 2 GENERAL REQUIREMENTS 2.1 Floor Sink The floor sink shall conform to the general require- ments outlined in Section 4 and surface shall be exam- ined for blemishes in accordance with Section 6 of ASME A112.19.1. 2.1.1 Floor Sink Drain Body. The drain body shall be smooth with rounded corners to eliminate bacterial catching surfaces. 2.1.2 Plastic Floor Sinks. The PVC plastic floor sinks shall conform to the general requirements outlined in Section 2 and workmanship and finish outlined in Section 3 of ANSI Z124.6.2.1.3 Strainers and Grates. The strainers and grates shall be accessible and removable for cleaning and maintenance. Grates must be aligned properly.ASME A112.6.7 pdf download.