ASME SA 240 pdf free download

ASME SA 240-2021 pdf free download.Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications.
1.1 This specification covers chromium, chromium-nickel.
and chromium-manganese-nickel stainless steel plate. sheet. and strip for pressure vessels and for general applications including architectural, building, construction, and aesthetic applications.
1.2 The values staled in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This specification is expressed in both inch-pound and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished in inch-pound units.
1.4 This standard does 1101 purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safei health, and em’iro,unenral practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of Jnternatjoiia Standards. Guides and Recoin— mendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced I)ocunients
2. I ASTM Standards:
A37() Test Methods and Definitions for Mechanical Testing of Steel Products
A4XO/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate. Sheet, and Strip
A923 Test Methods for Detecting Detrimental Intermetallic Phase in Duplex Austenitic/Ferrilic Stainless Steels
El12 Test Methods for Determining Average Grain Size E140 Hardness Conversion Tables for Metals Relationship Among Brincll Hardness, Vickers Hardness. Rockwell Hardness, Superficial Hardness, Knoop Hardness. Sclcroscope Hardness, and Leeb Hardness
E527 Practice for Numbering Metals and Alloys in the Unified Numbering Sysem (UNS)
2.2 SAE Standard:
J 1086 Practice for Numbering Metals and Alloys (UNS)
3. (;eneral Requirentents
3.1 The following requirements for orders for material furnished under this specification shall conform to the applicable requirements of the current edition of Specification
A4801A480M.
3.1.1 Definitions:
3.1.2 General requirements for delivery;
3.1.3 Ordering information:
3.1.4 Process;
3.1.5 Special tests;
3.1.6 Heat treatment;ASME SA 240 pdf download.